dynode

常見例句

• The voltages that should be applied to each dynode are a function of PMT design and are specified for each tube type.
  加到每個光電倍增管電極上的電壓決定于PMT的設計，并由每個管子的型號來確定。
• Electrons are accelerated by making the voltage of each successive dynode of the tube more positive than the previous one.
  使每個連續的光電倍增管電極的電壓都比它前面一個電極的電壓更高，這樣電子就得到加速。
• The picoammeter reads the current at the last dynode, which is equal to the anode current minus the current flowing to the previous dynode.
  皮安計在最后一個倍增管電極處讀取電流，此電流等于陽極電流減去流過前一個倍增管電極的電流。
• Our purpose is to deposit MgO films by reactive R.F. sputtering deposition, we completed the dynode devices on INVAR substrates.
  濺鍍制程是現今許多高科技元件的關鍵技術，因此薄膜的基礎科學及相關制程技術的研發為現今學術界及產業界的重大課題。
• The easiest way to accomplish this is to apply a potential across the entire tube and tap the dynode voltages off a voltage divider, as shown in Figure 4-13.
  做到這一點最容易的方法是給整個光電倍增管的兩端加上一個電壓，然后從一個分壓器的各個抽頭取得供給各個倍增管電極的電壓，如圖4-13所示。
• In this paper,the time property of its anode and dynode outputs has been studied and compared by using weak Cherenkov light,the results show that their time resolution is dependent on the number of the electrons collected at the same conditions.
  為了獲得多個倍增極的輸出信號,對其進行了相應的改進,利用弱契倫科夫光,研究了其陽極和倍增極的時間特性,并作了比較,結果表明相同條件下它們的時間分辨與所收集的電子數有很大關系。
返回 dynode