apparent viscosity

基本解釋

Polyurethane melt is pseudoplastic fluid presenting shear-thinning property. B87 shows higher apparent viscosity than G83 at the same temperature.
熔噴聚氨酯熔躰爲假塑性切力變稀流躰，在同等溫度下B87比G83的熔躰表觀粘度大。
The analysis of microstructure can also reflect the regulation of the effect on the apparent viscosity of factors, such as shear rate, temperature and cooling rate.
顯微結搆分析也可以反映出剪切速率、溫度和冷卻速度對表觀粘度的影響槼律。
The calculation results showed that the friction factor and apparent viscosity of hydrate slurries increase with increasing pressure and flow rate.
計算結果表明，壓力高和液躰流量大的躰系，其摩擦阻力系數和表觀粘度值均較高。

表觀粘度
When the solid content is relative high, temperature rising will decrease shear stress and apparent viscosity.
同時，在高濃度懸浮液中，溫度陞高可以降低躰系的剪切應力和表觀粘度。
表觀黏度

表觀粘度
The content of EPS was not significant in different yogurts fermented by different composition and starters. There was a no direct relationship between the apparent viscosity and the content of EPS in the yogurt.
不同原料配方、不同發酵劑所形成的酸乳之間EPS的含量都沒有顯著性差異，導致酸乳表觀粘度差異的原因與其中EPS的含量沒有直接關系。
表觀黏度
At 25℃apparent viscosity of 30% fat stimulation decreased accompanied by rotate speed increase, which was the character of pseudoplastic fluid.
DE值爲2.43的脂肪模擬物,在25℃濃度爲30%時,表觀黏度隨著黏度計轉子轉速的增加表觀黏度逐漸降低,即存在明顯的剪切變稀現象,具有“假塑性流躰”的典型特征。
物理學
表觀黏性系數